skip to main content
Resource type Show Results with: Show Results with: Search type Index

Computational Fluid Dynamics Simulations of the Effect of Water Injection Characteristics on TSCI: A New, Load-Flexible, Advanced Combustion Concept

Boldaji, Mozhgan Rahimi ; Sofianopoulos, Aimilios ; Mamalis, Sotirios ; Lawler, Benjamin

Journal of engineering for gas turbines and power, 2018-11-01, Vol.140 (11) [Peer Reviewed Journal]

Full text available

Citations Cited by
  • Title:
    Computational Fluid Dynamics Simulations of the Effect of Water Injection Characteristics on TSCI: A New, Load-Flexible, Advanced Combustion Concept
  • Author: Boldaji, Mozhgan Rahimi ; Sofianopoulos, Aimilios ; Mamalis, Sotirios ; Lawler, Benjamin
  • Is Part Of: Journal of engineering for gas turbines and power, 2018-11-01, Vol.140 (11)
  • Description: Homogeneous charge compression ignition (HCCI) combustion has the potential for high efficiency with very low levels of NOx and soot emissions. However, HCCI has thus far only been achievable in a laboratory setting due the lack of control over the start and rate of combustion and its narrow operating range. In the present work, direct water injection (WI) was investigated to solve the aforementioned limitations of HCCI. This new advanced combustion mode is called thermally stratified compression ignition (TSCI). A three-dimensional computational fluid dynamics (3D CFD) model was developed using CONVERGE CFD coupled with detailed chemical kinetics to gain a better understanding of the underlying phenomena of the water injection event in a homogeneous, low temperature combustion (LTC) strategy. The CFD model was first validated against previously collected experimental data. The model was then used to simulate TSCI combustion and the results indicate that injecting water into the combustion chamber decreases the overall unburned gas temperature and increases the level of thermal stratification prior to ignition. The increased thermal stratification results in a decreased rate of combustion, thereby providing control over its rate. The results show that the peak pressure and gross heat release rate (HRR) decrease by 37.8% and 83.2%, respectively, when 6.7 mg of water were injected per cycle at a pressure of 160 bar. Finally, different spray patterns were simulated to observe their effect on the level of thermal stratification prior to ignition. The results show that the symmetric patterns with more nozzle holes were generally more effective at increasing thermal stratification.
  • Language: English
  • Identifier: ISSN: 0742-4795
    EISSN: 1528-8919
    DOI: 10.1115/1.4040309

Searching Remote Databases, Please Wait

  • Searching for
  • inscope:(TRAILS-PRINT),scope:(D-01TRAILS_MSU_GFC),scope:(E-01TRAILS_MSU_GFC),primo_central_multiple_fe
  • Show me what you have so far